This Frisco Sportster tank is a direct bolt on for 2007 and up Sportsters which use electronic fuel injection (EFI). The custom tank will use the stock fuel pump and gas cap and is a direct bolt on part. No drilling, welding or fabrication of mounting points is required. This custom sporty tank is narrowed 1” in the back, and has the notorious flat spot removed from the top of the tank. At 2.5 gallons you’ll be looking stylish and have enough fuel to get further than just the nearest bar.
- 2.5 gal capacity
- 7 ¾” high
- 15” long
- 9/14” wide
- rear of tank reduced 1” from stock
- Raw Steel
- Utilizes stock fuel pump and fuel cap
Tanks are pressure tested at the factory, but it is best to test again before you paint it. Be sure fit of tank, mounting hardware, petcocks and gas caps are true prior to painting. No stress is applied to the tabs when bolting them to the frame, this can lead to cracking of welds. If needed, use leather or rubber washes to shim between the tabs and the backbone to ensure an even fit. Do not sand seams or welded edges of gas tanks, if needed use a thin spread of body filler prior to painting. Throttle Addiction warranties gas tank defects however we do not cover paint work. Ensure your tank arrived damage free BEFORE you paint!
2 Reviews Hide Reviews Show Reviews
Just put it on my 2015 sportster 72 with the new paint and it just finished off the lane splitter look that I was going for.
Man I put this tank on and it took my 2014 super lame sportster back a couple years in a good way. We smoked out my garage and pretended we were in the good Ole days ripping in the wind with no cares at all. Then my old lady yelled at me for stinking up the garage. But I went inside with a smile on my face. Tank looks bad fucking ass!